2001 Mazda MX-5

Central slight corrosion on chassis legs

Front Tyre slightly damaged/cracking or perishing n/s and o/s outer edges (5.2.3 (d) (ii))

Front n/s and o/s upper and lower ball joints and track rod end gaiters perishing

Front subframe and suspension components have surface corrosion

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Seat belt anchorage prescribed area is corroded but not considered excessive outer sill (7.1.1 (a) (i))

Power steering pipe/hose has slight seepage pipe above rear of subframe (2.1.5 (a))

Rear Subframe mounting prescribed area is corroded but not considered excessive n/s and o/s (5.3.6 (a) (i))

Rear Tyre slightly damaged/cracking or perishing n/s and o/s outer edges (5.2.3 (d) (ii))

Rear n/s and o/s antiroll bar link gaiters perishing

Rear subframe and suspension components have surface corrosion

small chip in windscreen

All brake calipers show signs of servicing/ repair. No visible sign of fluid leak.

Light corrosion on front suspension components.

Light corrosion on rear subframe & suspension components

Nearside Rear Parking brake down on efficiency compared with opposite side.

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Light corrosion on front suspension complements

Light corrosion on rear sub frame & suspension components.

Nearside Rear Sign they may have been a fluid leak on n/s rear brake caliper. Can not identify a leak at time of test.

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Light corrosion on front suspension components

Light corrosion on rear sub frame & suspension components

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Suspension component mounting prescribed area excessively damaged significantly reducing structural strength subframe and anti roll bar mounting points (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength subframe and anti roll bar mounting points (5.3.6 (a) (i))

Central slight surface corrosion to chassis rails

Front suspension components have surface corrosion

Nearside Front Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear suspension components have surface corrosion

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

corrosion on exhaust

light corrosion on front & rear suspension arms

minor corrosion on n/s & o/s outer sills at rear

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

handbrake mechanism damp on o/s rear caliper

n/s front gaiter on caliper damp

Nearside Registration plate lamp not working (1.1.C.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

handbrake mechanism damp on o/s rear caliper

n/s front gaiter on caliper damp

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside front brake grabbing slightly (3.7.A.2b)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Registration plate lamp not working (1.1.5c)

Offside Rear Stop lamp not working (1.2.1b)

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)