2005 Iveco Daily 35 C12 LWB

Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security all under body coated in underseal (6.2.2 (d) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Tyre worn close to legal limit/worn on edge all 4 on rear axle (5.2.3 (e))

Vehicle structure is corroded but structural rigidity is not significantly reduced all under body (6.1.1 (c) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced both sides outer sills (6.1.1 (c) (i))

HAND BRAKE LIGHT INOP

Nearside Front Outer Tyre worn close to the legal limit (4.1.E.1)

Offside Rear PANAL LIGHT BROKEN

Nearside Front Upper Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too high (1.8)

Offside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Steering system has excessive free play detected at the steering wheel (steering rack fitted) (2.2.A.1b)

HAND BRAKE LIGHT INOP

Nearside Front Outer Tyre worn close to the legal limit (4.1.E.1)

Offside Rear PANAL LIGHT BROKEN

Access panel cannot be secured in the closed position (6.4.1)

Nearside Front Upper Suspension arm rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Service brake indicates brake bind (3.7.D.2a)

Offside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Headlamp aim too low (1.8)

Offside Upper Front position lamp(s) not working (1.1.A.3b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake load sensing valve seized (3.6.E.3)

Rear Service brake indicates brake bind (3.7.D.2a)

Brake fluid warning lamp illuminated (3.6.G.2)

Nearside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Nearside Side repeater incorrect colour (1.4.A.2f)

Offside Front Upper Suspension arm rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Offside Side repeater incorrect colour (1.4.A.2f)

Offside Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake load sensing valve linkage seized (3.6.E.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Lower Suspension arm synthetic mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Shock absorber has a slightly worn bush (2.7.4)

Nearside Front Upper Suspension arm rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Parking brake lever has no reserve travel (3.1.6b)

Registration plate lamp not fitted (1.1.C.1b)

Nearside Front Lower Suspension arm synthetic mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Shock absorber has a slightly worn bush (2.7.4)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)