2014 Sfm Zz

Drive chain slightly loose (6.1.7 (c) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Exhaust noisy (8.1.1 (a))

Motorcycle structure is corroded but structural rigidity is not significantly reduced lots of paint covering corroded areas (6.1.1 (c) (i))

Rear Lower Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Headlamp aim too low (4.1.2 (a))

Rear Direction indicator obviously incorrectly positioned (4.4.3 (a))

Exhaust noisy (8.1.1 (a))

Drive chain slightly loose (6.1.7 (c) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Motorcycle structure is corroded but structural rigidity is not significantly reduced lots of paint covering corroded areas (6.1.1 (c) (i))

Rear Lower Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Steering headbearing has excessive wear or free play (2.2.2 (f) (i))

Nearside Front Shock absorber has a serious fluid leak fork seal failed (5.3.2 (b))

Rear Brake indicates excessive fluctuation of brake effort (1.2.1 (e))

Front Headlamp aim too low (4.1.2 (a))

Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Slight wear noise from front wheel bearings.

Throttle control functioning such that safe operation of the motorcycle is adversely affected throttle control sticks open & the carburettor linkage / cable is rubbing on the fuel pipe! (6.2.7 (a) (ii)) DANGEROUS

Headlamp aim too low (4.1.2 (a))

Slight wear noise from front wheel bearings.

Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Stop lamp not working (4.3.1 (a) (ii))

Headlamp aim too low (4.1.2 (a))

Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Nearside Rear Direction indicator missing (4.4.1 (a) (ii))

Nearside Rear Footrest missing (6.2.12 (a))

Offside Rear Direction indicator missing (4.4.1 (a) (ii))

Offside Rear Footrest missing (6.2.12 (a))

Rear Brake excessively binding (1.2.1 (f))

Rear Position lamp not working (4.2.1 (a))

Rear Stop lamp not working (4.3.1 (a) (ii))

Registration plate insecure (0.1 (a))

Riders seat insecure (6.2.5 (a) (ii)) DANGEROUS

Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Nearside switchgear loose on bars

Suspension arm pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Ignition switch is loose making engine cut out when wires are not touching

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Headlamp aim too low (1.6)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Headlamp aim too low (1.6)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)