1972 Rover Mini

Nearside Rear Shock absorber has a slightly worn bush perished rubbers (2.7.4)

Nearside head light, height is set on lower level

Offside Front bulk head corroded adj to heater vent strongly advise welding as is very close to structural mountings and door hinge area

Offside Rear Shock absorber has slight corrosion to the casing outer top cover missing (2.7.2a)

Passenger seat(s) missing at time of test all seats removed and seat belts ()

Rear Brake cable has wires broken but is not significantly weakened slightly corroded at body guides (3.5.1b)

Rear Brake has a slight discharge of oil may be anti corrosion coating on rear brake load valve itself (3.6.E.1)

Rear Brake hose has slight corrosion to ferrules n/s and o/s (3.6.B.4e)

both front tyres have slight misshape across tread

front valance adj to head light mountings corroded

n/s rear bumper corroded if it gets worse will cause sharp edge which is fail

Brake cable has wires broken but is not significantly weakened both slight on inner cables corrosion (3.5.1b)

Offside Front Road wheel with a slightly distorted bead rim slight (4.2.A.1a)

Offside Rear Shock absorber has slight external damage to the casing (2.7.2a)

Parking brake lever has little reserve travel (3.1.6b)

Standard fitment seat belt missing all passinger seats are removed ()

both front tyres have slight tread misshape close to fail

idle speed slightly eratic

rear brake load valve coated in greese

Brake cable has wires broken but is not significantly weakened both slight on inner cables corrosion (3.5.1b)

Nearside Headlamp aim too high (1.8)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Road wheel with a slightly distorted bead rim slight (4.2.A.1a)

Offside Rear Shock absorber has slight external damage to the casing (2.7.2a)

Parking brake lever has little reserve travel (3.1.6b)

Standard fitment seat belt missing all passinger seats are removed ()

both front tyres have slight tread misshape close to fail

idle speed slightly eratic

rear brake load valve coated in greese

Battery insecure has bunge strap still has exess movement (1.9.1)

Brake pipe inadequately clipped front to rear pipe at front of car fouling sub frame (3.6.B.1)

Brake pipe leaking rear load valve and pipe joint (3.6.A.1)

Nearside Headlamp aim aimed so that it dazzles other road users has no pattern or line (1.8.A.1a)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Lower Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Subframe mounting prescribed area is excessively corroded floor and wheel arch area (2.4.A.3)

Offside Rear Subframe mounting prescribed area is inadequately repaired inner floor to sub frame area weld not taken to car body (2.4.A.3)

Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Windscreen washer provides insufficient washer liquid both push button in dashboard loose (8.2.3)

Front Braking system leaking front to rear pipe at joint (3.6.A.1) DANGEROUS

Brake pivot worn but not seriously weakened n/s and o/s rear hand brake dust boots both split (3.5.1e)

Front Tie bar/rod rubber mounting deteriorated but not resulting in excessive movement n/s and o/s perished close to fail (2.4.G.2)

Nearside Front Standard fitment seat belt missing ()

Nearside Rear Trailing arm has slight play in a pin bearing (2.4.G.2)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Rear Rear wheel bearing has slight play (2.6.2)

Offside Rear Shock absorber has slight external damage to the casing also shaft is corroded is dry at time of test (2.7.2a)

Passenger seat(s) missing at time of test all seat , has only drivers seat ()

both front tyres have tread misshape close to fail

clutch pipe leaking

has water leak from engine

Nearside Front Brake pipe fouled by moving parts (3.6.B.2a)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

All under car has been heavily under sealed

Lots of welding repairs to under side of car

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Rear wheel bearing has slight play (2.6.2)

Nearside Steering rack gaiter deteriorated (2.2.D.2d)

Nearside outer track rod end joint cover split/missing

Oil leak

n/s/r corrsion behind bumper

slight front brake imbalence

All position lamps not working (1.1.A.3b)

Offside Steering rack gaiter split (2.2.D.2d)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Registration plate lamp not working (1.1.5c)

Nearside Steering rack gaiter deteriorated (2.2.D.2d)

Nearside outer track rod end joint cover split/missing

Oil leak

n/s/r corrsion behind bumper

slight front brake imbalence

Nearside Front Seat belt has a cut which has significantly weakened the webbing (5.2.2a)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Subframe mounting prescribed area is inadequately repaired (2.4.A.3)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Body has slight corrosion (6.1.B.2)

Nearside Front Seat belt damaged but not affecting the operation of the belt (5.2.2a)

Offside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Horn not working (1.6.2a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear brake recording little or no effort (3.7.B.5a)

Rear Exhaust system not adequately supported (7.1.1)

front brake application uneven (3.7.B.2)

front brakes release unevenly (3.7.B.4)

Parking brake: efficiency below requirements (3.7.C.1b) DANGEROUS