1989 Talbot Express 1000 P

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b))

Front Position lamp not working both (4.2.1 (a) (ii))

Horn not working (7.7 (a) (ii))

Main beam tell-tale not working (4.9.1 (a) (ii))

Nearside Front Seat belt not functioning as intended (7.1.2 (c))

Nearside Front Vehicle structure is fractured and structural rigidity is significantly reduced wheel arch (6.1.1 (a) (i))

Nearside Rear Seat belt buckle damaged (7.1.2 (d))

Offside Headlamp aim too high (4.1.2 (a))

Oil leaking excessively from engine (8.4.1 (a) (i))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Vehicle structure is fractured and structural rigidity is significantly reduced shape edges o/s rear arch (6.1.1 (a) (i))

Vehicle structure is fractured but structural rigidity is not significantly reduced rear cross member (6.1.1 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced substantial amount of previously welded repairs - covered in underseal (6.1.1 (c) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Exhaust system insecure broken / missing mountings (6.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Headlamp insecure (4.1.1 (c))

Integral body structure is corroded but structural rigidity is not significantly reduced substantial amount of previously welded repairs - covered in underseal (6.1.1 (c) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Both Outer Sills Soft in places

Exhaust Rubbers Perished & cracking but still securing exhaust

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive Floor area (5.2.6)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Rear Light lens poor condition

Offside Rear wheel bearing has slight play (2.6.2)

underside generally corroded and soft in places

Offside Front Suspension spring mounting prescribed area is excessively corroded Inner wing area (2.4.A.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Both Outer Sills Soft in places

Exhaust Rubbers Perished & cracking but still securing exhaust

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive Floor area (5.2.6)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Rear Light lens poor condition

Offside Rear wheel bearing has slight play (2.6.2)

underside generally corroded and soft in places

Exhaust has a minor leak of exhaust gases (7.1.2)

Front wheel bearing has slight play both (2.5.A.3c)

Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt both (2.2.C.1c)

both head lamps dim

seat frames badly corroded

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp not working on main beam (1.7.5a)

Offside Driver's seat insecure (6.2.A.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front wheel bearing has slight play both (2.5.A.3c)

Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt both (2.2.C.1c)

seat frames badly corroded

PREVIOUS WELDING REPAIRS HAVE BEEN HEAVILY UNDERSEALED VERY DIFFICULT TO ASSESS

front and rear wheel bearings have slight play

rear silencer rubber hanger missing but still secure

Direction indicators not working (1.4.A.2c)

Horn not working (1.6.2a)

Offside Headlamp insecure (1.7.3)

Offside Headlamp not working on dipped beam (1.7.5a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen wiper not operating automatically when switched on (8.2.1b)

PREVIOUS WELDING REPAIRS HAVE BEEN HEAVILY UNDERSEALED VERY DIFFICULT TO ASSESS

front and rear wheel bearings have slight play

rear silencer rubber hanger missing but still secure

Centre Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension component mounting prescribed area repaired, but not inappropriately (2.4.A.3)

Offside Front Suspension component mounting prescribed area repaired, but not inappropriately (2.4.A.3)

emissions only just acceptable and idle speed

oil leak near to excessive

Nearside Front Front position lamp(s) has less than 50% of the light sources illuminating (1.1.A.3b)

Offside Exhaust system not adequately supported (7.1.1)

Rear Stop lamp not working (1.2.1b)

Centre Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension component mounting prescribed area repaired, but not inappropriately (2.4.A.3)

Offside Front Suspension component mounting prescribed area repaired, but not inappropriately (2.4.A.3)

emissions only just acceptable and idle speed

oil leak near to excessive

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Rear Rear wheel bearing has excessive play (2.6.2)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Exhaust system not adequately supported (7.1.1)

Offside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Rear wheel bearing has excessive play (2.6.2)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Suspension component mounting prescribed area repaired, but not inappropriately (2.4.A.3)

Offside Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Suspension component mounting prescribed area repaired, but not inappropriately (2.4.A.3)

both front tyres side walls worn and perished nearly to excess

exhaust rubber missen

n/s front tyre in poor condition

play in o/s front wheelbearing

play in rear wheelbearings

rear spring mounts in poor condition

rear tyres in poor condition

Battery insecure (1.9.1)

Brake load sensing valve seized (3.6.E.3)

Front Headlamp aim too low (1.8)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Registration plate lamp not working (1.1.C.1d)

exhaust rubber missen

n/s front tyre in poor condition

play in o/s front wheelbearing

play in rear wheelbearings

rear spring mounts in poor condition

rear tyres in poor condition

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust emits clearly visible black smoke during acceleration (7.3.A.2c)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside Rear wheel bearing has excessive play (2.6.2)

Nearside Windscreen wiper not operating over a large enough area to give an adequate view (8.2.1c)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front wheel bearing has excessive play (2.5.A.3c)

Offside Rear wheel bearing rough when rotated (2.6.1)

Offside Windscreen wiper not operating over a large enough area to give an adequate view (8.2.1c)

Rear Exhaust system not adequately supported (7.1.1)

front brake application uneven (3.7.B.2)

Battery insecure

offside and nearside front brake discs pitted

Body has a sharp edge caused by corrosion (6.1.C.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc excessively pitted (3.5.1h)

Offside Rear position lamp(s) incomplete (1.1.4a)

Brake pedal spongy (3.3.B.1b)

Exhaust has a major leak of exhaust gases (7.1.2)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Body has a sharp edge caused by corrosion (6.1.C.1)

Nearside Front Headlamp insecure (1.7.3)

Nearside Front Headlamp not working on main beam (1.7.5a)

Nearside Outer Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front brake disc excessively scored (3.5.1h)

Offside Outer Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Offside Rear fog lamp emits a light other than red (1.3.2e)

Offside Rear position lamp(s) incorrect colour (1.1.A.3e)

Parking brake: efficiency below requirements (3.7.B.7)

Front brake disc excessively scored (3.5.1h)

Front registration plate insecure (6.3.1b)

Nearside Front Front position lamp(s) not in good working order (function impaired) (1.1.4a)

Nearside Front Headlamp aim too low (1.8)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Headlamp aim too high (1.8)

Offside Front Tie bar/rod corroded and seriously weakened (2.4.G.1)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Rear Registration plate lamp not working (1.1.5c)

Rear rear brake application uneven (3.7.B.2)

Rear registration plate deteriorated (6.3.1d)

Service brake: efficiency below requirements (3.7.B.7) DANGEROUS