1989 Fiat Panda

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Headlamp aim too high and too far to the right. (4.1.2 (a))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim too high and too far to the right. (4.1.2 (a))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust has a minor leak of exhaust gases front pipe to centre pipe joint (6.1.2 (a))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Oil leaking excessively from engine (8.4.1 (a) (i))

Exhaust has a minor leak of exhaust gases front pipe to centre pipe joint (6.1.2 (a))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Inner Suspension component mounting prescribed area is corroded but not considered excessive Wheel arch (5.3.6 (a) (i))

Nearside Inner Sill has slight corrosion

Offside Front Inner Sill has excessive corrosion outside of prescribed areas

Offside Front Inner Suspension component mounting prescribed area is corroded but not considered excessive Wheel arch (5.3.6 (a) (i))

Offside Inner Sill has slight corrosion

Parking brake lever defective but can be satisfactorily operated Little reserve travel (1.1.6 (d))

oil leak

rear arches corroding

rear handbrake effort just met requirements

rear leaf springs corroding

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Suspension component mounting prescribed area is excessively corroded both rear inner sills (2.4.A.3)

oil leak

rear arches corroding

rear leaf springs corroding

both rear arches corroding

both rear inner sills corroding

oil leak

Bonnet cannot be secured in the closed position (8.4.1)

both rear arches corroding

both rear inner sills corroding

oil leak

near side front slight play inner steering arm

various other areas has corrosion but not holed at time of test

Nearside Front Tyre tread depth below requirements of 1.6mm 1.5mm (4.1.E.1)

Offside Front Suspension component mounting prescribed area is excessively corroded chassis inner wing area (2.4.A.3)

various other areas has corrosion but not holed at time of test

Nearside Inner Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Inner Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Steering rack gaiter insecure (2.2.D.2d)

Offside Inner Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front All position lamps adversely affected by the operation of another lamp (1.1.A.3f)

Offside Front Direction indicator not working (1.4.A.2c)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Headlamp aim too low (1.8)

Nearside Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Nearside Headlamp aim too far to the right (1.8)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Stop lamp not working (1.2.1b)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too high (1.8)

Offside Rear Suspension spring mounting prescribed area is fractured (2.4.A.3)

Offside Registration plate lamp not working (1.1.C.1d)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Rear Body has slight corrosion (6.1.B.2)

Fuel tank leaking (7.2.3)