1982 Rover Mini

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Tyre worn close to the legal limit (4.1.E.1)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Front front brake juddering slightly (3.7.A.2b)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front Upper Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Upper Suspension arm has slight play in a ball joint (2.4.G.2)

advise both rear brake back plates corroding

advise rear sub frame slight corrosion

advise signs of both front inner wheel arches been fouled

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Service brake indicates brake bind (3.7.D.2a)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Service brake indicates brake bind (3.7.D.2a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Rear fog lamp not working (1.3.2b)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Body has slight corrosion (6.1.B.2)

reverse light insecure

unable to check rear wheel bearings

Nearside Headlamp aim too low (1.8)

Nearside front brake juddering severely (3.7.A.2b)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside front brake grabbing severely (3.7.A.2b)

Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Steering rack gaiter split (2.2.D.2d)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

floor generally heavily corroded

slight play in offside rack end

Brakes imbalanced across an axle (3.7.B.5b)

Direction indicator flashing less than 60 times a minute (1.4.A.2g)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside front brake juddering severely (3.7.A.2b)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

floor generally heavily corroded

slight play in offside rack end

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Offside front brake juddering severely (3.7.A.2b)

front brake application uneven (3.7.B.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

boot floor repaired from inside

fuel pipe coroded

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside front brake binding (3.7.B.1)

Nearside front brake juddering severely (3.7.A.2b)

Offside Rear fog lamp not working (1.3.2b)

Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Seat belt anchorage prescribed area is excessively corroded (5.2.6)

front brake application uneven (3.7.B.2)