1995 Rover Mini

front and rear brakes req adjustment

underside of vehicle covered in under seal

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle 70% off side rear cylinder leaking (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

underside of vehicle covered in under seal

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Headlamp aim too high (1.8)

Driver's seat insecure (6.2.A.1)

Electrical wiring damaged and bare wires exposed brake fluid top (1.9.2c)

Nearside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Subframe mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Nearside Side repeater incorrect colour (1.4.A.2f)

rear tyres cracking

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Offside Inner Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

rear tyres cracking

Offside Headlamp not working on dipped beam (1.7.5a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Lower Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Lower Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Headlamp aim too high (1.8)

Offside Rear Sub-frame attachment rubber mounting deteriorated resulting in excessive movement (2.4.G.2)