2006 Alfa Romeo Spider

Steering system has slight free play detected at steering wheel (2.2.A.1a)

Battery insecure (1.9.1)

Nearside Inner Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Nearside Rear front brake binding (3.7.B.1)

Offside Front front brake binding (3.7.B.1)

Offside Headlamp not working on main beam (1.7.5a)

Offside Inner Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Windscreen washer provides insufficient washer liquid (8.2.3)

Steering system has slight free play detected at steering wheel (2.2.A.1a)

Oil leak

Rear Anti-roll bar corroded but not seriously weakened (2.4.G.1)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Headlamp aim too high (1.8)

Nearside Headlamp does not operate immediately when selected on dipped beam (1.7.4a)

Offside Headlamp not working on main beam (1.7.5a)

Battery insecure

Front reg.plate slightly deteriorated.

Nearside Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Front Valve stem slightly misaligned (4.1.D.1e)

Offside Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

underneath body badly repaired

Horn not working (1.6.2a)

Nearside Front Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Brake hose excessively deteriorated (3.6.B.4d)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

All position lamps not working (1.1.A.3b)

Axle has inadequate clearance with the bump stop (2.4.A.1a)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front suspension has a suspension lower ball joint securing nut not locked (2.5.B.1a)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Headlamp aim beam image too far to the right (1.6.B4)

Registration plate lamp not working (1.1.5c)

Steering locking device missing (2.2.C.1g)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Tie bar/rod rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Track rod end loose (2.2.B.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)