2016 Generic Code

Cut in rear tyre tread

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Front Valve stem slightly damaged Tubless valve - slightly perrished (5.2.3 (j))

Front brake hose clamp - bolt in to bottom yoke loose

Wheel alignment slightly misaligned (2.4 (a))

Fork yoke insecure Top yoke stem nut loose (2.2.2 (d) (i))

Rear Brake master cylinder defective but brake still operating Piston partially siezed - push rod has excessive free play (1.1.10 (b) (i))

Rear Brake pedal has insufficient reserve travel (1.1.2 (a))

Rear Drive chain sprocket excessively loose Mounting bolts loose (6.1.7 (c) (i))

Front Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Cut in rear tyre tread

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Front Valve stem slightly damaged Tubless valve - slightly perrished (5.2.3 (j))

Front brake hose clamp - bolt in to bottom yoke loose

Wheel alignment slightly misaligned (2.4 (a))

Front brake lever has end broken off

Rear brake pedal slightly low

Shock absorber has a light misting of oil L/H fork seal (5.3.2 (b))

Swinging arm bearings have slight play

Wheel alignment slightly misaligned (2.4 (a))

Drive chain horseshoe locking device incorrectly fitted Fitted backwards (6.1.7 (j) (i))

Headlamp aim too low (4.1.2 (a))

Rear Brake excessively binding (1.2.1 (f))

Rear Brake pedal pivot has excessive free play Push rod to short - 0nly held in line with piston by rubber boot (1.1.1 (b))

Brake pedal is bent but brake can still be readily applied Bent up (1.1.2 (d))

Front brake lever has end broken off

L/H/F mudguard - rear bolt missing

Shock absorber has a light misting of oil L/H fork seal (5.3.2 (b))

Swinging arm bearings have slight play

Wheel alignment slightly misaligned (2.4 (a))