2003 Mitsubishi Fto

Nearside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Side repeater slightly discoloured (4.4.3 (a))

Offside Direction indicator slightly discoloured (4.4.3 (a))

Offside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Oil leak, but not excessive engine oil leak (8.4.1 (a) (i))

Emissions not tested (8.2.1.2 (d))

Nearside Side repeater incorrect colour (4.4.3 (a))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Side repeater incorrect colour (4.4.3 (a))

Offside Windscreen washer not working (3.5 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Front Service brake excessively binding (1.2.1 (f))

Offside Front Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wing within 10cms structial point (6.1.1 (c) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Brake pad(s) less than 1.5 mm thick front (1.1.13 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Offside Headlamp aim too low (1.8)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

O/S/HEADLAMP BORDERLINE. ENGINE OIL LEAK

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Brake pipe excessively corroded (3.6.B.2c)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust has part of the system excessively deteriorated (7.1.1a)

Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp not working on dipped beam (1.7.5a)

Service brake: efficiency below requirements (3.7.B.7)

rear brake recording little or no effort (3.7.B.5a)

Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

offside repeater lens missing.both rear tyretreads slightly out of shape.

Brakes imbalanced across an axle (3.7.B.5b)

Front Exhaust has part of the system slightly deteriorated (7.1.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)