1988 Talbot Express

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Central Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength under bonnet (5.3.6 (a) (i))

Offside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chalked (5.3.6 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Windscreen washer not working (3.5 (a))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Central Rear Lower Exhaust system insecure (6.1.2 (a))

Central Rear Lower Exhaust system insecure exhaust rubber snapped (6.1.2 (a))

Central Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Front Side repeater incorrect colour (4.4.3 (a))

Offside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength in engine bay across front of engine mounting. (5.3.6 (a) (i))

Offside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength in wheel arch. (5.3.6 (a) (i))

Front Electrical wiring inadequately secured engine bay (4.11 (a) (i))

Nearside Front Lower Vehicle structure is corroded but structural rigidity is not significantly reduced chassis rail. (6.1.1 (c) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Inner Steering linkage ball joint has slight play tie rod (2.1.3 (b) (i))

Offside Front Lower Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Offside Front Lower Vehicle structure is corroded but structural rigidity is not significantly reduced chassis rail. (6.1.1 (c) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

corrosion throughout underside but not within proscribed area's

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner wheel arch (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Cross member (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Chassis x 3 (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Chassis (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill end (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Driver's seat backrest cannot be secured in the upright position. (6.2.5 (b) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Slight corrosion; Inner & Outer sills, Floor, Chassis, Exhaust

2 exhaust mounts missing

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Inner Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive 1/4 panel (2.4.A.3)

Battery insecure (1.9.1)

Nearside Front Suspension component mounting prescribed area is excessively corroded inner wheel arch (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded rear spring eye (2.4.A.3)

Offside Front Inner Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Suspension component mounting prescribed area is excessively corroded chassis leg/inner wheel arch (2.4.A.3)

Offside Headlamp not working on dipped beam (1.7.5a)

2 exhaust mounts missing

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Inner Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive 1/4 panel (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded Inner arch in three areas as marked (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded Rear of leaf spring mount (2.4.A.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Seat belt anchorage prescribed area is excessively corroded Doorstep and outer/inner sill including jacking point (5.2.6)

Offside Front Steering component mounting prescribed area is excessively corroded Chassis cross member (2.2.C.1h)

Offside Front Suspension component mounting prescribed area is excessively corroded Nearly whole of inner arch (2.4.A.3)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Suspension component mounting prescribed area is excessively corroded Rear of inner arch and inner sill by rear of leaf spring (2.4.A.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Centre Exhaust system not adequately supported (7.1.1)

Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Rear wheel bearing has slight play (2.6.2)

inner wheel arches front showing corrision

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear wheel bearing has slight play (2.6.2)

Oil leak

Nearside Front Direction indicators not working (1.4.A.2c)

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Registration plate lamp not working (1.1.C.1d)

Rear fog lamp not working (1.3.2b)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear wheel bearing has slight play (2.6.2)

Oil leak

Nearside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Registration plate lamp not working (1.1.5c)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front brake disc excessively scored (3.5.1h)

Offside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

rear brake application uneven (3.7.B.2)