1988 Talbot Express

exhaust rubber mounts perished

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Bonnet cannot be secured in the closed position (3.1 (b) (i))

Driver's view of the road through the swept area of the windscreen significantly affected by an obstruction (3.1 (a) (ii))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt insecure (6.1.7 (g) (ii))

Nearside Front Road wheel badly distorted (5.2.2 (c) (i))

Nearside Headlamp insecure (4.1.1 (c))

Offside Headlamp aim too high (4.1.2 (a))

Rear fog lamp switch not operating in accordance with the requirements (4.5.3 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

exhaust rubber mounts perished

Exhaust mounting defective all (6.1.2 (a))

Nearside Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement tierod bush (5.3.4 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch (5.3.6 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement tierod bush (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill body pannel

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Service brake lagging in operation (1.2.1 (d))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch x2 (5.3.6 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Exhaust mounting defective all (6.1.2 (a))

Nearside Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement tierod bush (5.3.4 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch (5.3.6 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement tierod bush (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill body pannel

Oil leak, but not excessive (8.4.1 (a) (i))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill body pannel (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill body pannel (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Outer Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected sill (5.3.6 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch (2.4.A.3)

Nearside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch (2.4.A.3)

Offside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brake pedal spongy (3.3.B.1b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp not working on main beam (1.7.5a)

Registration plate lamp not working (1.1.C.1d)

Brake valve leaking (3.6.A.1) DANGEROUS

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch (2.4.A.3)

Nearside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch (2.4.A.3)

Offside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wing corroded/weak (2.4.A.3)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Seat belt anchorage prescribed area is corroded but not considered excessive both outer/inner sills weak (5.2.6)

Suspension component mounting prescribed area is corroded but not considered excessive both inner and outer sills weak (2.4.A.3)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear Front wheel bearing has slight play (2.5.A.3c)

Offside Rear Front wheel bearing has slight play (2.5.A.3c)

Oil leak

corrosion to o/s outer sill

n/s mirror repaired

n/s seatbelt click in outer case damages but works ok

rear engine mount starting to perish but no excessive movement

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Registration plate lamp not working (1.1.C.1d)

Offside Front Lower Ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Registration plate lamp not working (1.1.C.1d)

All position lamps not working (1.1.A.3b)

Position lamp switch faulty (1.1.A.1)

Nearside Front Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Vehicle structure slightly corroded within 30cm of towbar mounting (6.6.6)

Nearside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Nearside rear brake binding (3.7.B.1)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.5c)

Nearside Front Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Vehicle structure slightly corroded within 30cm of towbar mounting (6.6.6)

Nearside Rear Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Rear Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Rear Registration plate lamp not working (1.1.5c)

Steering system has slight free play detected at steering wheel (2.2.A.1b)

Steering system has slight free play detected at steering wheel (2.2.A.1b)

Brake pedal creeps down when held under pressure (3.3.B.1a)

Brake pedal spongy (3.3.B.1b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Parking brake mechanism/associated mounting prescribed area is excessively corroded (3.1.9)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Front position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Offside Rear fog lamp affected by the operation of another lamp (1.3.2f)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

body has corrosion

horn poor output

slight play in steering mechanism

vehicle has corrosion in prescribed and non prescribed areas

Exhaust has a major leak of exhaust gases (7.1.2)

Front constant velocity joint gaiter split (2.5.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

ALL TYRES HAVE CRACKS IN SIDE WALLS AND ARE DETERIORATED ADVISE TYRES ARE CHECKED AND REPLACED IF REQ

CHASSIS AND BODY HAS CORROSION IN PRESCRIBED AND NON PRESCRIBED AREAS

Front wheel bearing has slight play (2.5.A.3c)