1988 Yamaha Unknown

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

no lights fitted at time of test

Front Cannot see brake fluid level in reservoir, will check after test

No lights etc. fitted at time of test, "DAYTIME USE ONLY"

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement Suspension linkage (5.3.4 (a) (i))

Rear Position lamp light intensity significantly reduced (4.2.3 (a) (ii))

Front Headlamp light intensity severely reduced (4.1.4 (a))

Horn not working (7.7 (a))

Rear Stop lamp not working (4.3.1 (a) (ii))

Front Cannot see brake fluid level in reservoir, will check after test

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement Suspension linkage (5.3.4 (a) (i))

Clutch lever shortened so it cannot be readily operated (6.2.7 (b))

Headlamp aim unable to be tested (4.1.2 (b))

Headlamp light intensity severely reduced (4.1.4 (a))

Nearside Steering operation fouling on the fuel tank or bodywork on full lock (2.1.4 (b))

Offside Steering operation fouling on the fuel tank or bodywork on full lock (2.1.4 (b))

Rear Position lamp light intensity significantly reduced (4.2.3 (a) (ii))

Rear Stop lamp not working (4.3.1 (a) (ii))

Rear Suspension arm pin or bush excessively worn Suspension linkage (5.3.4 (a) (i))

Rear reflector missing (4.8.2 (a) (ii))

Drive chain so loose it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Drive chain so worn it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Cliutch lever pivot worn

Drive chain sprocket worn, but not excessively (6.1.7 (c) (i))

Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Nearside Rear Bolt missing from end of swinging arm

Steering headbearing has slight free play (2.2.2 (f) (i))