1987 Austin Mini Advantage

Nearside Rear Tyre slightly damaged (5.2.3 (d) (ii))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill/door piller (6.1.1 (c) (i))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced bulk head inside the vehicle (6.1.1 (c) (i))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Front Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill/door piller (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Rear Tyre slightly damaged (5.2.3 (d) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Steering column attachment defective (2.2.2 (d) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor/battery box (5.3.6 (a) (i))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Steering system excessively rough wear in the rack (2.1.1 (a))

Windscreen washer not working (3.5 (a))

Offside Front Suspension component attachment bracket/mounting likely to become detached front sub frame front offside pear bush (5.3.3 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Position lamp incorrect colour (4.2.3 (a) (i))

Offside Front Tyre slightly damaged (5.2.3 (d) (ii))

Offside Rear Position lamp incorrect colour (4.2.3 (a) (i))

Offside Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear battery box holed/corrodded

Offside Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Offside Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too high (1.8)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive shock absorber mounting bracket (2.4.A.3)

Nearside Front Passenger's seat insecure (6.2.A.1)

Nearside Rear Subframe mounting prescribed area is excessively corroded corner (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded corner (2.4.A.3)

Rear Passenger's seat cannot be secured in the upright position. (6.2.A.2)

Windscreen wiper does not clear the windscreen effectively both front (8.2.2)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive shock absorber mounting bracket (2.4.A.3)

Nearside Front Lower Shock absorber has an excessively worn bush (2.7.4)

Nearside Headlamp aim too high (1.8)

Nearside Rear Statutory seat belt missing (5.1.1)

Offside Headlamp aim too low (1.8)

Offside Rear Statutory seat belt missing (5.1.1)

Offside Steering rack gaiter split (2.2.D.2d)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Front Exhaust has a part missing (7.1.1a)

Front Exhaust system not adequately supported (7.1.1)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Stop lamp emits other than a steady red light (1.2.1e)

Engine/gearbox mounting(s) defective

Nail in nearside rear tyre

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Nearside Front Upper Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Rear Direction indicator slightly discoloured (1.4.A.2f)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear wheel bearing has slight play (2.6.2)

advise front to rear brake pipe needs rubber insulation in metal clips

Direction indicators not working (1.4.A.2c)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Nearside Rear Statutory seat belt missing (5.1.1)

Offside Rear Statutory seat belt missing (5.1.1)

Offside Rear position lamp(s) incorrect colour (1.1.A.3e)

Registration plate lamp not working (1.1.5c)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Nearside Front Upper Sub-frame has excessive play in a ball joint (2.4.G.2)

Offside Front Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Inner Rear Bonded suspension unit bonding failed and part of unit is likely to become displaced (2.4.F.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Service brake: efficiency below requirements (3.7.B.7)