1988 Fiat Ducato

Front Service brake excessively fluctuating (1.2.1 (e))

Nearside Front Brake hose excessively deteriorated (1.1.12 (b) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength jacking point/ floor (5.3.6 (a) (i))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring hanger (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength jacking point/ floor (5.3.6 (a) (i))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring hanger (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Position lamp switch insecure (4.2.2 (b))

Rear Body component insecure step (6.2.1 (a) (i))

Rear Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Offside Drive shaft bearing likely to break up (6.1.7 (b) (ii)) DANGEROUS

Hazard warning switch insecure (4.4.2 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Rear Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Service brake: efficiency below requirements (3.7.B.7)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside rear brake binding (3.7.B.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too low (1.8)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Rear fog lamp not working (1.3.2b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Direction indicators not working (1.4.A.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Front Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)

Front Windscreen wiper not operating automatically when switched on (8.2.1b)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front brake disc excessively pitted (3.5.1h)

Offside Rear Rear wheel bearing rough when rotated (2.6.1)

Offside Front brake disc slightly pitted (3.5.1h)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front brake disc slightly pitted (3.5.1h)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front brake disc slightly pitted (3.5.1h)

Nearside Front Headlamp not in good working order (not working) (1.2.4a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Brake pipe slightly corroded (3.6.B.2c)