2005 Mazda 5

Emissions not tested due to more than one minor exhaust leaks (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

bothsides inner sills have corrosion

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Central Front Registration plate does not conform to the specified requirements broken (0.1 (d))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Nail in tyre ()

nsr tyre worn inner edge

osr tyre worn inner edge

Suspension component mounting prescribed area is excessively corroded in nsr arch end of sill (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded in osr arch end of sill (2.4.A.3)

nsr tyre worn inner edge

osr tyre worn inner edge

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear coil spring broken (2.4.C.1a)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside Rear Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

2 rear tyres worn on inner edges

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

rear tyres low edge