2002 Piaggio Zip

Offside Rear Upper Stop lamp lens defective which has no effect on emitted light piece of corner broke off (4.3.1 (b) (i))

Offside Rear Upper Stop lamp lens defective which has no effect on emitted light piece of corner broke off (4.3.1 (b) (i))

Front Tyre tread not clearly visible (5.2.3 (e))

Front Brake pad(s) (sintered type) less than 1.0mm thick (3.2A1f(ii))

Nearside Rear shock absorber seal failed and leaking oil (2.4.A.1c)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Plate brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.B2b)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Tyre tread not clearly visible (4.1.3(i))

Rear Tyre has a bulge caused by separation or partial failure of its structure (4.1.2a(ii))

Front wheel bearings are excessively tight (2.3.5b)

Steering movement excessively stiff with the wheel raised (2.2.1b)

Exhaust mounting does not fully support the exhaust system (7.1.1.c)

Front Tyre worn close to the legal limit (4.1.3(i))

Front Tyre worn close to the legal limit (4.1.3(i))

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Front wheel bearings are excessively tight (2.3.5b)

Handlebar mounting clamp bolt loose (2.1.1a)

Horn sounds harsh or grating (1.7.3c)

Front Brake lever is inoperative (3.1.3c)

Front Brake lever is so short and the brake cannot be readily applied (3.1.3c)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Plate brake test No brake control achieves an efficiency of 30%. (3.3.B2a)

Rear Fairings insecure and likely to impede the steering (2.1.2e)

Registration plate insecure (6.3.1b)

Front Direction indicator affected by the operation of another lamp (1.5.1c)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Headlamp main beam flickers when tapped lightly by hand (1.2.2c)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Front Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Rear Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Headlamp aim too low (1.6.2)