2005 Hartford VR125H

Rear Shock absorber has a serious fluid leak (5.3.2 (b))

Rear Shock absorber has negligible damping effect (5.3.2 (b))

Stop lamp not working front control (4.3.1 (a) (ii))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Handlebar deformed but serviceable (2.2.1 (c) (i))

Front brake binding

Rear Wheel spoke slightly corroded. (4.2.1b)

battery condition poor engine has to be running for lights to work correctly

front tyre deteriorated

Steering movement excessively stiff with the weight on the lower bearing (2.2.1a) DANGEROUS

Headlamp masks/converters fitted

Rear Brake lining(s) close to minimum limit (3.2.A1f(i))

Headlamp masks/converters fitted

Drive chain slightly loose (6.2.1d)

Front Drive chain sprocket slightly worn (6.2.1e)

Rear Drive chain sprocket slightly worn (6.2.1e)

front tyre worn uneven

Front Direction indicator affected by the operation of another lamp (1.5.1c)

Headlamp aim too low (1.6)

Headlamp dipped beam affected by the operation of another lamp (1.2.2c)

Headlamp main beam affected by the operation of another lamp (1.2.2c)

Rear Direction indicator affected by the operation of another lamp (1.5.1c)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Drive chain slightly loose (6.2.1d)

Front Drive chain sprocket slightly worn (6.2.1e)

Rear Drive chain sprocket slightly worn (6.2.1e)

front tyre worn uneven

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Exhaust is leaking but is not excessively noisey (7.1.1b)

Brake lever is bent and the brake cannot be readily applied (3.1.3c)

Steering movement excessively stiff with the weight on the lower bearing (2.2.1a)