2010 Honda Cbf

Front Wheel bearing has slight play (5.1.3 (a) (i))

Front mudgaurd damaged/cracked

Motorcycle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear grabrail loose but secure

bodywork damaged on motorcycle

fairing damaged/loose but secure

Clutch lever bent (6.2.7 (b))

Exhaust mounting in poor rusty condition

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Lower Motorcycle structure is corroded but structural rigidity is not significantly reduced Main stand in poor worn out condition (6.1.1 (c) (i))

Rear Drive chain sprocket worn, but not excessively (6.1.7 (c) (i))

Steering headbearing slightly stiff or notchy Bike needs new headbearings (2.2.2 (f) (i))

Wheel alignment slightly misaligned Handle bars bent (2.4 (a))

Steering movement slightly 'notchy' (2.2.1b)

bike runing poorly i.e cuting out

sharp edge on off side front top fairing

Front Tyre worn close to the legal limit (4.1.3(ii))

Headlamp aim too high (1.6)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear wheel bearings have excessive free play (2.4.A.2c)

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front Brake fluid reservoir fluid level low (3.2.B1d)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Centre Rear Rear reflector on motorcycle missing (1.4.1)