2009 Mazda 5

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn replace asap split badly (5.1.2 (b) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

heat shield deteriorated and insecure above catalyst

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn replace asap split badly (5.1.2 (b) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

heat shield deteriorated and insecure above catalyst

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt droplink ball joint (5.3.4 (b) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Brake hydraulic reservoir fluid level significantly below minimum level (1.1.10 (d) (ii))

Brake performance unable to be tested (1.2.1 (g))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Brake hose damaged and likely to fail (1.1.12 (a)) DANGEROUS

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

exhaust heat shield loose

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

exhaust heat shield loose

Central hear shield deteriated

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive inner sill (7.1.1 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive inner sill (7.1.1 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Front Anti-roll bar ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Central hear shield deteriated

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive inner sill (7.1.1 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive inner sill (7.1.1 (a) (i))

Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear most bush (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear most bush (5.3.4 (a) (i))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear most bush (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear most bush (5.3.4 (a) (i))

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Front tyres bald edges

Nearside Front wiper split

Nearside Stop lamp not working (1.2.1b)

Child seat fitted not allowing full inspection of adult belt

Cuts in nearside front tyre, no cords showing.

Front tyres look under inflated.

Offside front tyre worn on inner edge.

Wiper blades wearing.