2005 Suzuki En 125

Front Direction indicator missing both (4.4.1 (a) (ii))

Rear Position lamp not working (4.2.1 (a))

Rear reflector missing (4.8.2 (a) (ii))

Stop lamp not working (4.3.1 (a) (ii))

Brake locking device missing brake rod nut missing (3.2.A1e)

Brake reaction bracket securing bolt(s) missing split pin missing (3.2.A1j)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Rear Motorcycle structure excessively corroded swing arm (6.1.1a)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Roller brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.A2b)

Wheel alignment incorrect which adversely affects the handling (2.5.1)

Front Roller brake test indicates a binding brake (3.3.A1a)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Uneven tread wear due to low tyre presure - Front

Rear Brake lining(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Roller brake test indicates a binding brake (3.3.A1a)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Roller brake test Higher brake efficiency normally obtainable. (3.3.A2b)

Uneven tread wear due to low tyre presure - Front

Exhaust is leaking but is not excessively noisey (7.1.1b)

Front brake binding, requiring caliper overhaul/replacment.

Tyres wearing unevenly due to incorrect tyre pressure.

Exhaust is leaking but is not excessively noisey (7.1.1b)

Front brake binding, requiring caliper overhaul/replacment.

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Tyres wearing unevenly due to incorrect tyre pressure.

Headlamp aim too low (1.6)

Steering movement slightly 'notchy' (2.2.1b)

front brake slight binding

Steering movement slightly 'notchy' (2.2.1b)

front brake slight binding

Front Steering movement slightly 'notchy' (2.2.1b)

Rear Brake lining(s) close to minimum limit (3.2.A1f(i))

front brake binding slightly

gear change linkage worn and corroded

Fuel cap sealing washer deteriorated (7.2.2c)

Front brake binding slightly

Drive chain worn but not considered excessive (6.2.1e)

Gear change linkage worn and corroded

Rear Brake lining(s) close to minimum limit (3.2.A1f(i))

Rear reflector on motorcycle missing (1.4.1)