2007 Mitsubishi Lancer

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Suspension arm pin or bush worn but not resulting in excessive movement axle bushes (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Suspension arm pin or bush worn but not resulting in excessive movement lower arm rear bushes (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Suspension arm pin or bush worn but not resulting in excessive movement lower arm rear bushes (5.3.4 (a) (i))

Nearside Rear Inner Position lamp not working (4.2.1 (a))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Registration plate lamp does not illuminate simultaneously with the position lamps (1.1.C.1a)

Rear fog lamp excessively damaged so that it is not visible from a reasonable distance (1.3.2d)

front brake pads getting low

rear anti roll bar has slight movement in rubber bushes

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)