2009 Mazda 5

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Front Headlamp has a product on the lens but not seriously reducing light output both sides (4.1.4 (b))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake pad(s) wearing thin both side (1.1.13 (a) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Rear Brake pad(s) less than 1.5 mm thick both side (1.1.13 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin both side (1.1.13 (a) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced Minor corroded in the rear side of the car (6.1.1 (c) (i))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Exhaust has a minor leak of exhaust gases BACK BOX (6.1.2 (a))

UNDERBODY CORROSION

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Suspension component pin or bush slightly worn suspension arm mounting (5.3.4 (a) (i))

Offside Front Suspension component pin or bush slightly worn suspension arm mounting (5.3.4 (a) (i))

engine covers and under trays fitted

Nearside Front Suspension component pin or bush slightly worn suspension arm mounting (5.3.4 (a) (i))

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure 205/50/ZR17 93WXL (5.2.3 (d) (i))

Offside Front Suspension component pin or bush slightly worn suspension arm mounting (5.3.4 (a) (i))

engine covers and under trays fitted

Nearside Front Front suspension has slight movement at a wishbone pin or bush rear bush deterioated (2.5.A.1c)

Offside Front Front suspension has slight movement at a wishbone pin or bush rear bush deterioated (2.5.A.1c)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

n/s/f tyre tread worn low outer edge

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Inner Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Nearside Rear Trailing arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Trailing arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

2x screws in nearside rear tyre

Inner Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Trailing arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Trailing arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

exhaust heat shield loose over petrol tank

coolant bottle top missing

Offside Front Lower Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)