2004 Mazda 2

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Lower engine mount lower bush split

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Upper Brake pipe excessively corroded (1.1.11 (c))

Lower engine mount lower bush split

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Front Headlamp aim too high (4.1.2 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Headlamp not working on dipped beam (1.7.5a)

Front Brake pad(s) wearing thin (3.5.1g)

engine linht on

Nearside Stop lamp not working (1.2.1b)

Offside Stop lamp not working (1.2.1b)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Seat belt pre-tensioner has been activated

engine management light on

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Seat belt pre-tensioner has been activated

engine management light on

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Headlamp aim beam image kick up to the offside (1.8)

Offside Headlamp aim too high (1.8)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Headlamp aim beam image kick up to the offside (1.8)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Stop lamp not working (1.2.1b)

advise o/s/f tyre and n/s/r tyre on 2-3mm on the outer edge