2003 Mazda 3

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Body panel slightly loose wing corroded (6.2.1 (a) (i))

Nearside Front top strut mounting has play/worn

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Body panel slightly loose wing corroded (6.2.1 (a) (i))

Nearside Front top strut mounting has play/worn

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Fuel Pipe/s corroded ()

Nearside Front Body component slightly loose bottom of wing corroded (6.2.1 (a) (i))

Nearside Front sill coverd

Offside Front Body panel slightly loose bottom of wing corroded (6.2.1 (a) (i))

Offside Rear Exhaust mounting defective back box (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

under body showing signs of corrosion and to various components

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer sill (6.2.2 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Brake pad(s) less than 1.5 mm thick x2 (1.1.13 (a) (ii)) DANGEROUS

Fuel Pipe/s corroded ()

Nearside Front Body component slightly loose bottom of wing corroded (6.2.1 (a) (i))

Nearside Front sill coverd

Offside Front Body panel slightly loose bottom of wing corroded (6.2.1 (a) (i))

Offside Rear Exhaust mounting defective back box (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

under body showing signs of corrosion and to various components

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Fuel Pipe/s corroded ()

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear axle beam corroded

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

parking brake efficiency is low @16%

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

parking brake efficiency is low @16%

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front registration plate deteriorated (6.3.1d)

Offside Stop lamp not working (1.2.1b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Nail in offside rear tyre

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Rear Wheel nut(s) missing (4.2.A.1e)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside front brake juddering severely (3.7.A.2b)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

REAR BRAKE PADS GETTING LOW