2009 Vauxhall Combo

smoke emissions on the high side

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Front Exhaust has a minor leak of exhaust gases flexi (6.1.2 (a))

Nearside Brake pipe corroded, covered in grease or other material front to rear Brake pipe corroded at rear (1.1.11 (c))

Nearside Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Nearside Front Tyre worn close to legal limit/worn on edge Tyre worn close (5.2.3 (e))

Nearside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive inner wing (5.3.6 (a) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive inner wing (5.3.6 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Service brake fluctuating, but not excessively both sides (1.2.1 (e))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened both worn on inner face (1.1.14 (a) (ii))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both worn on inner face (1.1.14 (a) (ii))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.A.3)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

O.S.R. tyre worn inner edge

Nearside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

O.S.R. tyre worn inner edge

Fuel system component leaking (7.2.3)

Nearside Front Body has a projection caused by damage (6.1.C.1)

Nearside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)