1986 Rover 2600

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust emissions exceed level of metered smoke for a non-turbo charged engine (8.2.2.2 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Drag link end ball joint has slight play TRACK ROD (2.1.3 (b) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Drag link end ball joint has slight play TRACK ROD (2.1.3 (b) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced inner arch (6.1.1 (c) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Front Oil leaking excessively from engine going on to calliper (8.4.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner arch (front) (6.1.1 (c) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner arch (6.1.1 (c) (i))

Offside Front Side repeater incorrect colour (4.4.3 (a))

Offside Front Side repeater lens defective such that the emitted light is adversely affected lens missing (4.4.1 (b) (ii))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Tyre has a tear, caused by separation or partial failure of its structure side wall (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Shock absorbers has a slightly worn bush lower bushes (5.3.2 (c))

Offside Rear Shock absorbers has a slightly worn bush lower bushes (5.3.2 (c))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Steering rack gaiter split (2.2.D.2d)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front Steering rack gaiter split (2.2.D.2d)

Offside Front Steering rack gaiter split (2.2.D.2d)

Parking brake lever has no reserve travel (3.1.6b)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Exhaust engine idle speed too high (7.3.A.2a)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Vehicle structure has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Inner Front Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Nearside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Braking system leaking (3.6.A.1)

Nearside Rear Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Offside Front Headlamp aim too high (1.8)

Offside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tie bar/rod rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Shock absorber has a serious fluid leak (2.7.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Oil leak

exhaust blow

front brake hoses perishing

Exhaust mounting missing (7.1.1b)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)