1987 Honda MTX125

Rear Wheel spoke slightly bent (5.2.2 (d))

Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Headlamp aim unable to be tested (4.1.2 (b))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Headlamp not working on main beam (4.1.1 (a) (ii))

Horn not working (7.7 (a))

Rear Brake excessively binding (1.2.1 (f))

Exhaust slightly loose (6.1.2 (a))

Rear Wheel spoke slightly bent (5.2.2 (d))

Drive chain slightly tight (6.1.7 (k) (i))

Central Front Brake binding but not excessively (1.2.1 (f))

Central Front Brake binding but not excessively (1.2.1 (f))

Central Rear Rear reflector missing (4.8.2 (a) (ii))

Central Rear Registration plate incorrect (0.1 (c))

Central Rear Tyre tread not clearly visible (5.2.3 (e))

Rear Wheel spoke slightly bent (5.2.2 (d))

Rear sub-frame slightly distorted

Speedo cable missing

Speedo meter needle broken/damaged.

Wheel alignment slightly misaligned

Front Brake fluid reservoir fluid level significantly below minimum level (1.1.10 (d) (ii))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Rear Position lamp not working (4.2.1 (a))

Rear Wheel spoke excessively loose (5.2.2 (d))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate lamp does not illuminate simultaneously with the position lamp(s) (4.7.2 (a))

Stop lamp not working both (4.3.1 (a) (ii))

Wheel alignment incorrect which adversely affects the handling (2.4 (a))

Front Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Front Wheel spoke slightly corroded (5.2.2 (d))

Steering headbearing has slight free play (2.2.2 (f) (i))

nearside handlebar grip slightly loose

Drive chain slightly tight (6.2.1d)

Drive chain worn but not considered excessive (6.2.1e)

Front Wheel spoke slightly corroded. (4.2.1b)

Front brake pipe unions slightly corroded

Front brake slightly dragging

Front tyre slightly perished

Rear Wheel spoke slightly corroded. (4.2.1b)

Rear tyre slightly perished

Wheel alignment slightly misaligned. (2.5.1)

Brake caliper(s) securing bolt(s) loose (3.2.A1j)

Brake lever is so short and the brake cannot be readily applied (3.1.3c)

Direction indicators flashing more than 120 times per minute (1.5.1c)

Drive chain excessively tight (6.2.1d)

Front Roller brake test indicates a binding brake (3.3.A1a)

Front wheel bearings are excessively rough (2.3.5b)

Front wheel spindle securing nut locking device insecure (2.3.5a)

Headlamp aim too low (1.6)

Throttle operating incorrectly (6.2.1f)

Brake hose unions slightly corroded

Drive chain worn but not considered excessive (6.2.1e)

Front Tyre slightly perished

Rear Tyre slightly perished

Wheel alignment slightly misaligned. (2.5.1)