1987 Honda XL125

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Rear Shock absorber has a reduced damping effect slow to return (5.3.2 (b))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Drive chain sprocket worn, but not excessively sprocket carrier (6.1.7 (c) (i))

Drive chain sprocket worn, but not excessively sprocket carrier (6.1.7 (c) (i))

Throttle operating incorrectly (6.2.7 (a) (i))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Wheel alignment slightly misaligned (2.4 (a))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Rear Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

slight play in rear sprocket carrier bearing

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Rear Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Headlamp aim too low (4.1.2 (a))

Front Wheel has a slightly distorted bead rim. (4.2.2)

Rear Wheel has a slightly distorted bead rim. (4.2.2)

Drive chain excessively tight (6.2.1d)

Front Wheel has a slightly distorted bead rim. (4.2.2)

Rear Wheel has a slightly distorted bead rim. (4.2.2)

Rear suspension component loose swingarm bolt loose (2.4.A.1a)

Throttle operating incorrectly not returning (6.2.1f)

Clutch lever shortened. (6.2.1g)

Exhaust slightly deteriorated (7.1.1a)

Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.2a(i))

Nearside Rear Footrest insecure (6.2.1a)

Clutch lever shortened. (6.2.1g)

Drive chain slightly loose (6.2.1d)

Exhaust slightly deteriorated (7.1.1a)

Lower Rear suspension slightly corroded (2.4.A.2d)

Rear Drive chain sprocket slightly worn (6.2.1e)

Brake lever is short but brake can still be readily applied (3.1.3c)

Clutch lever shortened. (6.2.1g)

Front Wheel has a slightly distorted bead rim. (4.2.2)

slight cut in off side sidewall of front tyre

Drive chain worn but not considered excessive (6.2.1e)

Drive chain slightly loose (6.2.1d)

Front Wheel has a slightly distorted bead rim. (4.2.2)

Wheel alignment slightly misaligned. (2.5.1)

sidestand pivot bolt locknut missing

Exhaust is leaking but is not excessively noisey (7.1.1b)

Rear Wheel alignment slightly misaligned. (2.5.1)

Rear Wheel has a slightly distorted bead rim. (4.2.2)

Rear Drive chain sprocket worn to excess (6.2.1e)

Brake lever is short but brake can still be readily applied (3.1.3c)

Exhaust is leaking but is not excessively noisey (7.1.1b)

Brake lever is short but brake can still be readily applied (3.1.3c)

Exhaust is leaking but is not excessively noisey (7.1.1b)

Headlamp aim too low (1.6)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Front suspension has inadequate damping effect. (2.3.6c)

Headlamp aim too high (1.6)

Nearside Rear Footrest missing (6.2.1a)

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Offside Rear Footrest missing (6.2.1a)

Rear reflector on motorcycle missing (1.4.1)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Direction indicators flashing less than 60 times a minute (1.5.1c)

Front Roller brake test indicates a binding brake (3.3.A1a)

Wheel alignment incorrect which adversely affects the handling (2.5.1)

Rear Tyre worn close to the legal limit (4.1.3(ii))