1987 Mercedes-benz 420

Nearside Front Outer Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Inner Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Exhaust emissions - engine idle speed too high (8.2.1.2 (e))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b))

Nearside Front Outer Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Inner Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive behind rear springs (5.3.6 (a) (i))

Steering box has slight free play detected at steering wheel (2.3 (a) (i))

Nearside Front Exhaust has a minor leak of exhaust gases manifold appears cracked (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

general corrosion

Offside Headlamp aim too low (4.1.2 (a))

Front headlamps dipped beam working in sidelamp position on switch and not working at dipped position on switch

Nearside Front Exhaust has a minor leak of exhaust gases manifold appears cracked (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

general corrosion

Offside Rear Position lamp not working (4.2.1 (a))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps both lamps (4.7.1 (b) (ii))

Nearside Front Outer Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Outer Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Centre Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

corrosion to nearside rear handbrake cable.

Nearside Headlamp aim too low (1.8)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim too low (1.8)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear position lamp(s) not working (1.1.A.3b)

Centre Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

corrosion to nearside rear handbrake cable.

petrol cap seal poor

wiper blades worn

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Offside Rear fog lamp not working (1.3.2b)

petrol cap seal poor

wiper blades worn

Nearside Rear Bonded suspension unit deteriorated but can function as intended (2.4.F.3)

Offside Rear Bonded suspension unit deteriorated but can function as intended (2.4.F.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.3.B.1)

Nearside Front Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Nearside Rear rear brake binding (3.7.B.1)

Offside Front Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)