2005 Triumph Sprint

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pedal is bent but brake can still be readily applied (1.1.2 (d))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Front Suspension component has excessive wear or free play Headstock bearings very notchy (5.3.3 (d))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Exhaust noisy (8.1.1 (a))

Front Brake indicates slight fluctuation of brake effort Front discs slightly distorted (1.2.1 (e))

Exhaust noisy (8.1.1 (a))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Front Tyre worn close to the legal limit (5.2.3 (e))

Front Brake disc(s) has slight run out (3.2.A1m)

Brake pad(s) close to minimum limit (3.2.A1f(i))

Front brake lever has a lot of travel compared to brake effort until lever is pumped repeatedly but does lock on roller brake test.

Nail in rear tyre

Steering control has reduced clearance at full lock not affecting the riders operation of the controls (2.1.2b)

Steering movement slightly 'notchy' (2.2.1b)

Front Tyre worn close to the legal limit (4.1.3(ii))

An item not tested (Manual)

Steering control fouling between components which interferes with the free movement of the steering (2.1.2a)

Front Tyre worn close to the legal limit (4.1.3(ii))

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Riders footrest rubbers show high wear

Rear Brake pad(s) (sintered type) less than 1.0mm thick (3.2A1f(ii))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))