2010 Ssangyong Rexton

Brake performance unable to be tested due to bind and pads on metal (1.2.1 (g))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Rear Service brake excessively binding Both sides (1.2.1 (f))

Windscreen wiper does not clear the windscreen effectively Both (3.4 (b) (ii))

Offside Rear Anti-roll bar linkage ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge Inner edge (5.2.3 (e))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

advise unable to fully inspect brake pipes on top of chassis