2004 Iveco Daily 35S12 SWB

Brake load sensing valve defective and function impaired (3.6.E.3)

Front Sub-frame corroded and seriously weakened (2.4.G.1)

Fuel cap/sealing device missing (7.2.4a)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Inner Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Stop lamp not working (1.2.1b)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Suspension arm corroded and seriously weakened shock absorber mount (2.4.G.1)

Offside Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Central Seat belt damaged but webbing not significantly weakened (5.2.2a)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear position lamp(s) has light sources not illuminating, but not more than 50% (1.1.A.3b)

fuel cap damaged

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear position lamp(s) has light sources not illuminating, but not more than 50% (1.1.A.3b)

fuel cap damaged

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Centre Brake pipe excessively corroded (3.6.B.2c)

Front Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Nearside Front Front position lamp(s) has less than 50% of the light sources illuminating (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

front subframe covered in surface rust

Emissions not tested (7.4.B.1)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

front subframe covered in surface rust

Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

rear diff slightly leaking oil

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

offside rear light damaged

Horn not working (1.6.2a)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Towbar component insecure (6.6.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Towbar component insecure (6.6.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

offside rear light damaged

Parking brake lever has little reserve travel (3.1.6b)

slight travel on foot brake

Brake pedal spongy (3.3.B.1b)

Front registration plate letter/figure incomplete (6.3.1c)

Horn not working (1.6.2a)

Nearside Front Body has a sharp edge caused by damage (6.1.C.1)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Towbar component insecure (6.6.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

brake pedal travel indicates adjustment of repair may be required

nearside and offside rear shock absorber shrouds not fixed

Brake pedal anti-slip provision missing (3.3.A.1b)

Horn not working (1.6.2a)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Parking brake lever has no reserve travel (3.1.6b)

Registration plate lamp not working (1.1.C.1d)

rear brake application uneven (3.7.B.2)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

brake pedal travel indicates adjustment of repair may be required

nearside and offside rear shock absorber shrouds not fixed

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Upper Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brake pedal anti-slip provision incomplete (3.3.A.1b)

Driver's seat insecure (6.2.A.1)

Horn not working (1.6.2a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Brake pipe slightly chafed (3.6.B.2c)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Upper Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

n/s/r shock absorber dust cover broken and insecure

surface cut on n/s/r tyre on outer wall

Nearside Front Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Lower Leaf spring has excessive wear in a shackle pin and/or bush (2.4.B.2)

Nearside Rear Upper Brake pipe excessively chafed (3.6.B.2c)

Offside Front Body has a sharp edge caused by damage (6.1.C.1)

Offside Front Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Upper Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Lower Leaf spring has excessive wear in a shackle pin and/or bush (2.4.B.2)

Offside Rear Rear position lamp(s) incomplete (1.1.4a)

Rear Body has a sharp edge caused by damage (6.1.C.1)

Rear registration plate dirty (6.3.1d)

n/s/r shock absorber dust cover broken and insecure

surface cut on n/s/r tyre on outer wall

Emissions not tested (7.0)

Nearside Front Upper Torque/reaction arm has excessive play in a pin/bush (2.4.G.2)

Nearside Registration plate lamp not working (1.1.5c)

Offside Registration plate lamp not working (1.1.5c)