2010 Kymco Pulsar

Offside Front Footrest insecure (6.2.12 (a))

Rear Tyre not fitted in accordance with side wall instructions Rear tyre fitted against side wall direction instruction (5.2.3 (i))

front brake fluid level low

GEARBOX FAULT IS EVIDENT. FAILURE IS IMMINENT.

Drive chain excessively tight (6.1.7 (k) (i))

Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Stop lamp not working (4.3.1 (a) (ii))

Suspension arm pin or bush excessively worn swinging arm (5.3.4 (a) (i))

GEARBOX FAULT IS EVIDENT. FAILURE IS IMMINENT.

rear tyre poss punture

Front Brake excessively binding (1.2.1 (f))

Headlamp aim too high (4.1.2 (a))

Headlamp not working on main beam (4.1.1 (a) (ii))

Rear Stop lamp not working (4.3.1 (a) (ii))

Registration plate does not conform to the specified requirements badly deteriorated (0.1 (d))

Steering headbearing has excessive wear or free play (2.2.2 (f) (i))

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

rear tyre poss punture

Exhaust is leaking and excessively noisey (7.1.1b)

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Rear Roller brake test indicates a binding brake (3.3.A1a)

Steering control fouling between components which interferes with the free movement of the steering (2.1.2a)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Front Headlamp aim too high (1.6)