2000 Volkswagen Transporter

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced all (6.1.1 (c) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is inadequately repaired chassis (5.3.6 (a) (i))

Offside Rear Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced all (6.1.1 (c) (i))

Driver's view Items removed from driver's view prior to test (3.1 (a) (ii))

Horn not working properly (7.7 (a) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Inner Driver's door catch deteriorated so the door cannot be readily opened or closed (6.2.3 (c) (i))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Rear Brake slack adjuster advise adjustment Handbrake cable to caliper mount partially seized (1.1.18 (a))

Offside Rear Inner Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Exhaust mounting defective (6.1.2 (a))

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive step (7.1.1 (a) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Horn not loud enough to be heard by another road user (7.7 (c) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive step (7.1.1 (a) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

corrosion on outer sills n/s and o/s

Nearside Inner Suspension component mounting prescribed area is excessively corroded sill several places (2.4.A.3)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Rear Exhaust system not adequately supported (7.1.1)

corrosion on outer sills n/s and o/s

corrosion underneath vehicle

slight corrosion underneath

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Suspension arm has excessive play in a ball joint all 4 (2.4.G.2)

slight corrosion underneath