2007 Ssangyong Rexton

Offside Rear Tyre worn close to the legal limit 2mm (4.1.E.1)

Brake pedal creeps down when held under pressure (3.3.B.1a)

Electronic stability system warning lamp indicates a fault (3.4.1c)

Nearside Front Anti-roll bar has excessive play in a pin/bush D bush (2.4.G.2)

Nearside Rear Anti-roll bar has excessive play in a pin/bush D bush (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded top shock mount (2.4.A.3)

Nearside Rear Upper Shock absorber insecure (2.7.2b)

Offside Front Anti-roll bar has excessive play in a pin/bush D bush (2.4.G.2)

Offside Front Brake pad(s) less than 1.5 mm thick inner pad (3.5.1g)

Offside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Rear Anti-roll bar has excessive play in a pin/bush D bush (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded chassis at brake pipe mount (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Parking brake lever has no reserve travel (3.1.6b)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit 2mm (4.1.E.1)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Oil leak ()

Rear Vehicle structure has slight corrosion chassis slight corrosion (6.1.B.2)

Nearside Rear Rear position lamp(s) insecure (1.1.A.3a)

Nearside Rear rear brake recording little or no effort only slightly working (3.7.B.5a)

Offside Rear Rear fog lamp not working (1.3.2b)

Parking brake: efficiency below requirements (3.7.C.1b)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a) DANGEROUS

Front Vehicle structure has slight corrosion chassis rusty and under radiator (6.1.B.2)

Front foglamps not working

Front registration plate deteriorated but not likely to be misread cracked but still readable (6.3.1d)

Rear Vehicle structure has slight corrosion chassis slight corrosion (6.1.B.2)

Front Suspension component mounting prescribed area is corroded but not considered excessive both sides chassie behind covers inner archs (2.4.A.3)

Front Upper Suspension component mounting prescribed area is corroded but not considered excessive both sides shock mounts (2.4.A.3)

Front cross member heavy corrosion

Front subframe corrosion

Nearside Rear Upper Suspension arm attachment bracket/mounting worn but its strength is not seriously reduced (2.4.G.1)

Rear both sides body mounts corrosion

Rear both sides towbar mount corrosion

Rear heavy under seal under jeep on repairs

e m light on

hand brake high may need ajustment

Electronic stability system switch faulty (3.4.5)

Electronic stability system warning lamp indicates a fault (3.4.1c)

Nearside Headlamp aim too far to the right (1.8)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Upper Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Headlamp aim too far to the right (1.8)

Offside Rear Upper Suspension arm attachment bracket/mounting insecure (2.4.G.1)

Rear Registration plate lamp not working both (1.1.C.1d)

Front Suspension component mounting prescribed area is corroded but not considered excessive both sides chassie behind covers inner archs (2.4.A.3)

Front Upper Suspension component mounting prescribed area is corroded but not considered excessive both sides shock mounts (2.4.A.3)

Front cross member heavy corrosion

Front subframe corrosion

Nearside Rear Upper Suspension arm attachment bracket/mounting worn but its strength is not seriously reduced (2.4.G.1)

Rear both sides body mounts corrosion

Rear both sides towbar mount corrosion

Rear heavy under seal under jeep on repairs

e m light on

hand brake high may need ajustment

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Stop lamp not working (1.2.1b)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Upper Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Rear fog lamp not working (1.3.2b)

Registration plate lamp not working (1.1.C.1d)

Offside Rear Tie bar/rod attachment bracket/mounting corroded and its strength is seriously reduced (2.4.G.1) DANGEROUS

Offside Front Upper Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Prop-shaft universal joint worn

Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

Vehicle structure has slight corrosion (6.1.A.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both front brake discs slightly corroded

o/s/r bump stop mounting corroded

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Front Rear position lamp(s) not working (1.1.A.3b)

Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Upper Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Prop-shaft universal joint worn

Vehicle structure has slight corrosion (6.1.A.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both front brake discs slightly corroded

o/s/r bump stop mounting corroded

Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Stop lamp not working (1.2.1b)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.C.1d)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Track rod end ball joint has excessive play (2.2.B.1f) DANGEROUS

Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Front Tyre worn close to the legal limit (4.1.E.1)

Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Registration plate lamp not working (1.1.5c)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Rear Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Rear Registration plate lamp not working (1.1.5c)