2007 Ssangyong Rexton

All vehicle structure has corrosion and is under sealed.

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Suspension arm ball joint has slight play o/s/f, n/s/f (5.3.4 (a) (i))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Rear fog lamp not working (4.5.1 (a) (ii))

All vehicle structure has corrosion and is under sealed.

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Suspension arm ball joint has slight play o/s/f, n/s/f (5.3.4 (a) (i))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Vehicle structure has slight corrosion (6.1.A.1)

Front Vehicle structure has slight corrosion (6.1.A.1)

Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive support crossmember (2.4.A.3)

Rear Vehicle structure has slight corrosion heavy corrosion (6.1.A.1)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

all welding is under sealed hard to check

fuel tank under guard obscuring view of chassis repair

Front wheel bearing has excessive play both (2.5.A.3c)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Vehicle structure has excessive corrosion which adversely affects braking or steering by trailing arm mounting (6.1.A.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Brake pipe excessively corroded front to rear (3.6.B.2c)

Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Vehicle structure has excessive corrosion which adversely affects braking or steering by trailing arm front mounting (6.1.A.1)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive support crossmember (2.4.A.3)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

front chassis corrosion

rear chassis heavy corrosion

Nearside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front coil spring broken (2.4.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen wiper does not clear the windscreen effectively both (8.2.2)

Nearside rear parking brake recording little or no effort (3.7.B.6a) DANGEROUS

rear diff pinion oil seal leaking

Front wheel bearing has slight play (2.5.A.3c)

Nearside Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear Stop lamp not working (1.2.1b)

rear parking brake recording little or no effort (3.7.B.6a)