2008 Mazda RX-8

Emissions unable to be completed exhaust blow (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Front Lower Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Front Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Rear Lower Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Front Upper Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Nearside Rear Lower Integral body structure is deformed but structural rigidity is not significantly reduced sill (6.1.1 (a) (i))

Rear Passenger seat(s) missing at time of test all ()

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced both sides inner sills (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

all suspension and brake components corroded

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Headlamp levelling device inoperative Level sensor damaged (4.1.5 (a))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Upper Suspension arm pin or bush worn but not resulting in excessive movement nearside and offside (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Upper Suspension arm pin or bush worn but not resulting in excessive movement nearside and offside (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Upper Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Upper Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Upper Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Upper Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear coil spring broken (2.4.C.1a)

Offside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear coil spring broken (2.4.C.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Upper Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Upper Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside front brake application uneven (3.7.B.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Anti-roll bar linkage damaged and seriously weakened (2.4.G.1)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

front pads look low

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

registration plate fitted to the front does not have black characters on a white background (6.3.2a)

registration plate fitted to the rear does not have black characters on a yellow background (6.3.2b)

front pads look low