2008 Hyundai Matrix

Brake lever has insufficient reserve travel (1.1.2 (a))

Front Exhaust has a major leak of exhaust gases exhaust flex (6.1.2 (a))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Tyre worn close to legal limit/worn on edge on legal limit (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

nearside rear wing damaged

Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Exhaust has a minor leak of exhaust gases flexi joint (7.1.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Exhaust has a minor leak of exhaust gases flexi joint (7.1.2)

both front tyres wearing on inner edge

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)