1986 Land Rover Forward Control

Brake master cylinder/servo mounting prescribed area is excessively corroded (1.1.21 (e) (i))

Front Registration plate insecure (0.1 (a))

Nearside Rear Brake prescribed area is excessively corroded back plate (1.1.21 (e) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Brake prescribed area is excessively corroded back plate (1.1.21 (e) (i))

Oil leaking excessively from engine (8.4.1 (a) (i))

Power steering pipe/hose leaking (2.1.5 (a))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced crossmember (6.1.1 (c) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Steering locking device ineffective Clamps defective (2.1.3 (d))

Offside Rear Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Chassis (6.1.1 (c) (i))

Offside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Shock mounting (5.3.6 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive Spring mounting plate (5.3.6 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Brake pressure build up slow (1.1.3 (b))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced outrigger (6.1.1 (c) (i))

Rear Exhaust mounting defective (6.1.2 (a))

heavily undersealed inc brake pipies

rear brake plates corroded

All direction indicators not working (4.4.1 (a) (ii))

All position lamps not working (4.2.1 (a))

Headlamp not working on dipped beam both (4.1.1 (a) (ii))

Headlamp not working on main beam both (4.1.1 (a) (ii))

Horn not working (7.7 (a) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Brake pressure build up slow (1.1.3 (b))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced outrigger (6.1.1 (c) (i))

Rear Exhaust mounting defective (6.1.2 (a))

heavily undersealed inc brake pipies

rear brake plates corroded

center seat removed

chassis on rear getting rustey

Centre Statutory seat belt missing (5.1.1)

Nearside Front Brake hose excessively deteriorated (3.6.B.4d)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

chassis on rear getting rustey

Front Exhaust has a major leak of exhaust gases (7.1.2)

Horn not working (1.6.2a)

Offside Front Lower Shock absorber has an excessively worn bush (2.7.4)

Power steering pipe(s) or hose(s) excessively corroded (2.3.2)

Power steering pipe(s) or hose(s) leaking (2.3.3b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Suspension arm has excessive play in a ball joint (2.4.G.2)

Chassis very rusty

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

front brake application uneven (3.7.B.2)

Chassis very rusty

Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp aim too high when the centre of the headlamp is above 850mm from the ground (1.6.B3)