1985 Honda H100

Brake component insecure rear brake drum arm was not pushed onto cam correctly, which resulted in failure on the brake test (1.1.21 (c))

Brake rod insecure rear brake rod incorrect, as goes over top of wheel spindle, not underneath. (1.1.15 (c))

Drive chain horseshoe locking device incorrectly fitted clip link is missing (6.1.7 (j) (i))

Rear Shock absorber has negligible damping effect inadequate damping of rear suspension (5.3.2 (b))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Shock absorber has a serious fluid leak both front forks leaking oil (5.3.2 (b))

Rear Brake has no recorded effort at a wheel linkage arm failed during brake test operation, arm came off cam (1.2.1 (a) (ii)) DANGEROUS

Rear Valve stem seriously misaligned (5.2.3 (j)) DANGEROUS

Rear Wheel more than one fixing loose wheel has side to side movement, and wheel spindle rocks as if wheel not fully tightened, or spacer missing (5.2.1 (a) (ii)) DANGEROUS

Headlamp aim too high (4.1.2 (a))

Rear reflector defective or damaged by up to 50% of the reflecting surface rear reflector is not reflective (4.8.1 (a) (i))

Steering headbearing slightly stiff or notchy very slight, only just noticeable (2.2.2 (f) (i))

Stop lamp slightly affected by the operation of another lamp affected by indicators, battery may require charging (4.3.3 (b))

Wheel alignment slightly misaligned (2.4 (a))

both front and rear tyre pressures are low and both require re-inflating

front of seat not fixed down, but is secured by the rear end

no pillion footrests fitted at time of test, but does have a grabrail fitted

Exhaust silencer insecure (8.1.1 (b) (i))

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)