1986 Ford Orion

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Play in steering rack inner joint(s) ()

Nearside Rear inner arch at bumper corrosion in non presscribed area

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides sills/inner arches (5.3.6 (a) (i))

Rear Wheel bearing has slight play both sides (5.1.3 (a) (i))

outer sill covers

slight oil leak

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Wheel bearing slightly noisy both sides (5.1.3 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill/arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill/inner arch (5.3.6 (a) (i))

Play in steering rack inner joint(s) ()

Rear Wheel bearing has slight play both (5.1.3 (a) (i))

outer sill covers

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both perished (5.3.4 (a) (i))

Front Play in steering rack inner joint(s) ()

Nearside Front Wheel bearing slightly noisy and rear (5.1.3 (b) (i))

Nearside Rear inner arch corrosion

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides inner sills (5.3.6 (a) (i))

outer sill covers

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive end of sill (5.3.6 (a) (i))

Play in steering rack inner joint(s) ()

sill covers

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Rear Tyre tread depth below requirements of 1.6mm both sides (5.2.3 (e)) DANGEROUS

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive end of sill (5.3.6 (a) (i))

Play in steering rack inner joint(s) ()

sill covers

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front both sides track control arm bushes slight perished

Offside Front Wheel bearing slightly noisy very slight (5.1.3 (b) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear end of sill slight corrosion

Play in steering rack inner joint(s) ()

sill covers

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

hand brake high

int mirror missing

near side rear inner body /ach corroded non presscribed area

sill covers

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear wheel cylinder leaking (3.6.A.1)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

hand brake high

int mirror missing

near side rear inner body /ach corroded non presscribed area

near side rear tyre cracking

sill covers

front anti roll bar "rear" bushes starting to cravk up.

fuel cap req;

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Position lamp switch faulty (1.1.A.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)