2003 MG Zt+ Cdti

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Front Registration plate inscription illegible (0.1 (b))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Brake lever has insufficient reserve travel (1.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Headlamp aim too far to the right (4.1.2 (a))

Offside Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leaks

Oil leaks

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Steering rack gaiter insecure (2.2.D.2d)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Front Brake pads worn low

Rear E haunt silencer rubber poor condition

Rear Steel brake pipes badly corroded

Nearside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Power steering ram(s) leaking from a failed component (2.3.3b)

Front Brake pads worn low

Rear E haunt silencer rubber poor condition

Rear Steel brake pipes badly corroded

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)