2008 Yamaha FZ6 S2

Exhaust noisy (8.1.1 (a))

Drive chain slightly loose (6.1.7 (c) (i))

Exhaust noisy both (8.1.1 (a))

Clutch lever shortened (6.2.7 (b))

Exhaust noisy (8.1.1 (a))

Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Rear Wheel alignment slightly misaligned (2.4 (a))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Horn not working (7.7 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Engine mounting/bracket excessively loose (6.1.8 (a) (ii)) DANGEROUS

Clutch lever shortened (6.2.7 (b))

Exhaust noisy (8.1.1 (a))

Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Rear Wheel alignment slightly misaligned (2.4 (a))

Rear reflector obviously incorrectly positioned (4.8.2 (a) (i))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front tyre is stepped/feathered on the tread.

Rear Tyre worn close to the legal limit (5.2.3 (e))

Front Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Headlamp aim too high (4.1.2 (a))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Nearside handle bar grip slightly loose

Headlamp aim too low (4.1.2 (a))

Horn not working (7.7 (a) (ii))

Nearside handle bar grip slightly loose

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Drive chain slightly loose (6.2.1d)

Drive chain slightly loose (6.2.1d)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear reflector on motorcycle missing (1.4.1)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Footrest insecure (6.2.1a)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))