2013 Vauxhall Combo

Engine mounting damaged but not to excess (6.1.8 (a) (i))

Nearside Front Upper Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Brake performance unable to be tested (1.2.1 (g))

Emissions unable to be completed (8.2.2.2 (e))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Engine mounting damaged but not to excess (6.1.8 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Upper Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Clutch pedal anti slip provision missing.

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside DRL inop

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Lamp lense cracked but does not emit white light.

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Rear Exhaust mounting defective Back box rear mounting badly deteriorated. (6.1.2 (a))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Central Rear Seat belt buckle damaged (7.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Front Steering system excessively rough Top mounting very rough. (2.1.1 (a))

Clutch pedal anti slip provision missing.

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside DRL inop

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Lamp lense cracked but does not emit white light.

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Rear Exhaust mounting defective Back box rear mounting badly deteriorated. (6.1.2 (a))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Front Windscreen washer not working (3.5 (a))

Nearside Front Front passenger door cannot be opened from outside the vehicle (6.2.3 (a))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt split (5.3.4 (b) (ii))

clutch pedal rubber missing

Nearside Front Front passenger door cannot be opened from outside the vehicle (6.2.3 (a))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

clutch pedal rubber missing

rear exhaust rubber mounting split

Front passenger door cannot be opened from outside the vehicle (6.2.B.1b)

Offside Headlamp not working on dipped beam (1.7.5a)

rear exhaust rubber mounting split