MOT Status
ExpiredMileage
117,108 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Exhaust has a major leak of exhaust gases front exhaust blowing excessive (6.1.2 (a))
Headlamp levelling device inoperative (4.1.5 (a))
Nearside Front Headlamp aim too low (4.1.2 (a))
Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))
Nearside Front Lower Suspension arm pin or bush excessively worn n/s/f lower wishbone rear bush (5.3.4 (a) (i))
Offside Front Headlamp aim not tested (4.1.2 (b))
Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))
Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced excessive corrosion to o/s/f floor with in 30cm of seat mount (6.1.1 (c) (i))
Offside Front Lower Suspension arm pin or bush excessively worn o/s/f lower wishbone rear bush (5.3.4 (a) (i))
Windscreen washer provides insufficient washer liquid (3.5 (a))
Brake disc worn, pitted or scored, but not seriously weakened front discs on inner face (1.1.14 (a) (ii))
Exhaust mounting defective front hanger mount corroded off (6.1.2 (a))
Integral body structure is corroded but structural rigidity is not significantly reduced under side of vehicle very rusty (6.1.1 (c) (i))
Offside Front Shock absorbers has light misting of oil (5.3.2 (b))
Offside Front Tyre worn close to legal limit/worn on edge o/s/f tyre worn very close to limit (5.2.3 (e))
Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))
Oil leak, but not excessive oil leak on engine (8.4.1 (a) (i))
Sub-frame corroded but not seriously weakened front (5.3.3 (b) (i))
Sub-frame corroded but not seriously weakened rear (5.3.3 (b) (i))
Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))
Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear wishbone bush (5.3.4 (a) (i))
Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))
Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))
Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear wishbone bush (5.3.4 (a) (i))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))
Rear Seat belt anchorage prescribed area is corroded but not considered excessive sill area (7.1.1 (a) (i))
Nearside Front Position lamp not working (4.2.1 (a) (ii))
Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))
Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))
Offside Front Position lamp not working (4.2.1 (a) (ii))
Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))
Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear wishbone bush (5.3.4 (a) (i))
Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))
Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))
Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear wishbone bush (5.3.4 (a) (i))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))
Rear Seat belt anchorage prescribed area is corroded but not considered excessive sill area (7.1.1 (a) (i))
Child Seat fitted not allowing full inspection of adult belt ()
Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)
Child Seat fitted not allowing full inspection of adult belt ()
Nearside Rear Shock absorber has a light misting of oil (2.7.3)
Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Windscreen washer provides insufficient washer liquid (8.2.3)
Offside Headlamp aim too low (1.8)
Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)
rear section exhaust tatty
Brakes imbalanced across an axle (3.7.D.2c)
Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Nearside Rear Service brake indicates brake bind (3.7.D.2a)
Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Front Brake pad(s) wearing thin (3.5.1g)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
Nearside Front Tyre worn close to the legal limit (4.1.E.1)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
How Reliable is the Mazda 3?
Based on 2,040,939 MOT tests across 164,053 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
BJ07 HUP is a 2007 Mazda 3 in Blue with a 1,598cc petrol engine. This vehicle has been through 17 MOT tests with a personal pass rate of 70.6%.
Across all 2007 Mazda 3 models, the average MOT pass rate is 74.7% with a typical mileage of 68,986 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Mazda 3 fails its MOT is tyre tread depth below requirements of 1.6mm, accounting for 40,716 recorded failures. If you're considering buying BJ07 HUP, it's worth having these areas checked by a mechanic before committing.
The Mazda 3 typically stays on UK roads for around 22 years. At 19 years old, this Mazda 3 is approaching the upper end of the typical lifespan for this model.
Frequently Asked Questions
How do I check the history of BJ07 HUP?
You can check the full history of BJ07 HUP by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was BJ07 HUP registered?
BJ07 HUP is a 2007 Mazda 3, first registered on 31 March 2007.
Is BJ07 HUP safe to buy?
The MOT history for BJ07 HUP shows 17 tests with a 70.6% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does BJ07 HUP have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on BJ07 HUP. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.