2003 Lexus IS200

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Brake performance unable to be tested (1.2.1 (g))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner and outer sill (6.1.1 (c) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner and outer sill (6.1.1 (c) (i))

Offside Front Hydraulic brake calliper damaged and braking performance affected (1.1.16 (a) (ii)) DANGEROUS

Rear Brake disc in such a condition that it is seriously weakened both sides (1.1.14 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick both sides (1.1.13 (a) (ii)) DANGEROUS

Front Windscreen washer provides insufficient washer liquid both sides (3.5 (a))

Offside Front Brake performance not tested caliper binding (1.2.1 (g))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Power steering malfunctioning (2.1.5 (a))

Front Brake pad(s) less than 1.5 mm thick o/s and n/s (1.1.13 (a) (ii)) DANGEROUS

Front Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Front Drag link end ball joint has slight play both sides (2.1.3 (b) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Suspension component pin or bush slightly worn both sides (5.3.4 (a) (i))

Rear Wheel bearing slightly noisy both sides (5.1.3 (b) (i))

Suspension component pin or bush slightly worn both sides (5.3.4 (a) (i))

Front Hydraulic brake calliper damaged (1.1.16 (a) (i))

Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Rear Tyre worn close to legal limit/worn on edge Both Side (5.2.3 (e))

slight play in nearside front bottom ball joint

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front front brake application uneven (3.7.B.2)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)