2002 Subaru Legacy

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Offside Front Hydraulic brake calliper inadequately mounted lower bolt not secured (1.1.16 (c) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Offside Front Tyre has a tear, caused by separation or partial failure of its structure tyre (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive inner sill (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive tyre inner arch (7.1.1 (a) (i))

Offside Rear tyre bald inner edge

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear inner sills corroded

Rear subframe corroded

Front registration plate deteriorated but not likely to be misread (6.3.1d)

nearside wiper slightly smearing

rear inner sills slightly corroded

rear subframe slightly corroded

brake servo corroded

front numberplate damaged

nearside front tyre on limit and worn heavy inner edge

rear subframe corroded

Battery insecure (1.9.1)

Nearside Headlamp aim too low (1.8)

Nearside Headlamp insecure (1.7.3)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner wheel arch (2.4.A.3)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Headlamp aim too high (1.8)

Offside Rear Anti-roll bar linkage insecure (2.4.G.1)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Seat belt anchorage prescribed area is excessively corroded outer wheel arch (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer arch (2.4.A.3)

brake fluid on minimum

brake servo corroded

exhaust blow at manifold

front numberplate damaged

nearside front drop link play close too excessive

nearside front tyre on limit and worn heavy inner edge

rear anti roll bar d bushes worn

rear discs heavily corroded

rear inner sills corroded

rear subframe corroded

Centre Rear Statutory seat belt missing (5.1.1)

Nearside Rear Seat belt retracting mechanism defective (5.2.5b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Lower Front suspension locking device missing (2.5.A.4)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Registration plate lamp not working (1.1.C.1d)

Centre Rear Statutory seat belt missing (5.1.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Front suspension locking device missing (2.5.A.4)

Offside Front Shock absorber has a serious fluid leak (2.7.3)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Registration plate lamp not working (1.1.C.1d)

Offside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Headlamp not working on main beam (1.7.5a)

Offside Front position lamp(s) not working (1.1.A.3b)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Registration plate lamp not working (1.1.C.1d)

Front exhaust heatshields rattling/corroded

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Registration plate lamp not working (1.1.5c)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Shock absorber has negligible damping effect (2.7.5)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Front exhaust heatshields rattling/corroded

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)