1985 Rover Mini

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Door sill soft & small rusty hole

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust system poor condition & slight leak

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Hazard warning tell tale not working correctly Tell tail light on rocker switch N/W (1.4.B.1e)

Nearside Front Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Nearside Front front brake binding (3.7.B.1)

Offside Front Lower Seat belt insecurely fixed to the vehicles structure Bolt into sill not fully home (5.2.1a)

Offside Front Subframe mounting prescribed area is excessively corroded Drivers footwell rusty & holed (2.4.A.3)

Offside Front front brake binding (3.7.B.1)

Offside Rear Subframe mounting prescribed area is inadequately repaired Mounting looks fibreglass filled & not welded (2.4.A.3)

Offside Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' Sun visor does not stay folded up (8.3.1b)

Exhaust has a minor leak of exhaust gases Poor condition (7.1.2)

car been havely painted throw out

Battery insecure (1.9.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement both mountings (2.4.G.2)

Offside Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement both mounting (2.4.G.2)

Offside Front Subframe mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Rear rear brake binding (3.7.B.1)

Offside Registration plate lamp not working (1.1.C.1d)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Coolant leak ()

Coolant leak ()

car been havely painted throw out